Follow these steps in configuring your IP Phone:

1. Disconnect the telephone from the internet (LAN)
2. Power down the phone and then power it back up.
3. Press the telephones button.
4. To set the IP address press button 18 on the lower right side. Enter the IP number. If the number is only 2 digits, you must add a 0 in front to complete the three digit request. Depress the # key when the IP number is entered.
5. To set the subnet address, press button 17 on the lower right side. Enter the subnet number and depress the # key.
6. To set the default gateway address press button 16 on the lower right side. Enter the gateway address number and depress the # key.
7. To set or check the NBX gateway address depress button 15 on the lower right side. The number should be 204.234.227.65.

Check with your district tech coordinator to get your IP number, subnet, and IP gateway addresses. If you are not sure what they were, contact John Stritt - jstritt@esu10.org or IP phone #3106.

To set up your voice mail, depress the blue message button on the left front of the IP Phone. Follow the directions for setting password, voice message, etc.

If you forget your password, contact John Stritt (3106) or jstritt@esu10.org.

If you wish to change your messaging information, depress the message button, enter the password, and follow the directions.

TVDEC Support Page

TVDEC Homepage